Ant
Kit Basher
Posts: 113
|
Post by Ant on Feb 10, 2011 8:40:53 GMT
Been making good progress on this since Sunday but just noticed a small issue - when building the cab interior there's a little round dohicky labelled B20 that's supposed to go on the dash - but B20 is also half the engine block! The closest I can find is a tiny serrated knob that I can't find a home for elsewhere, but it doesn't look like the picture.
Anyone else resolved this?
As an aside - be careful when assembling the chassis - it's quite easy to end up with the whole thing warped if the cross beams* are not absolutely straight...
Ant
*"One o'crossbeams gone out'o'skew on't treddle..."
|
|
Lonewolf
Moderator
Gods Country
Posts: 2,551
|
Post by Lonewolf on Feb 10, 2011 9:58:54 GMT
I'll try and find an instruction sheet but I think I've only got one for the long wheelbase Bedford. Mind you should be the same.
As for your chassis, assemble and make sure its straight then place under a chassis dewarping tool. Otherwise known as a large Java textbook!
|
|
Ant
Kit Basher
Posts: 113
|
Post by Ant on Feb 10, 2011 12:50:16 GMT
The problem I had was I'd stuck all the beams down one side & let set. Then added the other side and realised it was a bit wonky... Would PHP work instead of Java in this case? Ant
|
|
|
Post by Fatty on Feb 10, 2011 19:42:09 GMT
it sounds like the oil filler cap from ontop of the engine.
|
|
Ant
Kit Basher
Posts: 113
|
Post by Ant on Feb 10, 2011 21:23:25 GMT
Indeed that is what it was. So I'm none the wiser....
Ant
|
|