Braided pipes technique

[hazmod]

I used made my braided pipes with plastic pieces with wire
First, any Detail master Braided pipes will fixed with modeller red bolts, with 10mm drill, and twisted insert to Braided tube. and Put small PVC amount on end of braided pipe, and fixed insert the red bolt with Jewellery wire with super glue and PVC.

I used drilled bolts for Mechincial pieces with Formula One cars. I made up the braided pipes with wire insert to pieces of bolts.
I made up this braided pipes to cooling system and fuel pump system and oil flows. I'm confidential this braided pipes for 1/12 Scale F1 cars. You will checked my modelersite.net online with my document about Walter Wolf WR 1 progess.

I made up this braide pipes with metal bolts or plastic bolts with jewellery wire, to fit with mechincial pieces.

You will think about it

[NoelSmith]

A very cheap way of getting braided pipes is get some very thin screened cable and strip off the outside plastic insulation. May be available from Maplins or similar.

[hazmod]

I used fit this braided pipe with cable insert 0.5mm rod or jewellery fine rod with 0.5mm. I have fitted my braided pipes with jewellery rod with my Walter Wolf WR1. You will see my showroom for modelersite online. I will fitted this detail master with detail master nut, with insert jewellery rod with suerglue. no good plastic rod, caused broken.1.2mm or 2.5mm braided pipes used fitted with jewellery rod or brass rod with 0.5mm. If 0.5mm or 0.6mm braided pipes can drilled down to fit insert the plastic pieces.